Thread: Height to lower pole?
View Single Post
  #3   Spotlight this post!  
Unread 23-06-2002, 22:59
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: Height to lower pole?
Posted by Joe Ross.   [PICTURE: SAME | NEW | HELP]


Coach on team #330, Beach Bot II, from Hope Chapel Academy and NASA/JPL, NASA ARC.

Posted on 2/2/2000 4:25 PM MST


In Reply to: Re: Height to lower pole? posted by Michael Betts on 2/2/2000 3:46 PM MST:



FIRST specified a tolerance of 1 inch for the height of the bar. Better not design you robot any taller that 29 inches if you want to get under the bar

Joe Ross
Team 330


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.