|
Re: pic: 1251 Side Plates
Here is some information:
-The plates are 3/8" thick, and where the pockets are located it went down to 1/8". It is a little thicker (7/32") on the part where the gearbox goes.
-We will be using the dog gear from AndyMark, however we machined our own dog pockets in the gears, shafts, piston holder, etc. This allows us to have the ratios we want, and the motors we want... 
-Each plate weights 2.89 lbs.
-Yes, 8 wheel drive with 6 always in contact with the ground.
-The correct CNC time per plate is about 1 hour and 45 minutes.
__________________
Team 1251 The Techtigers
2010 FL Regional Winner (BIG thanks to 86 and 1612)
2009 FL Regional Finalist (BIG thanks to 79 and 744)
2008 FL Regional Winner, FL GM Industrial Design, SC GM Industrial Design
2007 FL Regional Winner, FL GM Industrial Design, Palmetto Regional Finalist, Palmetto Motorola Quality.
2006 Palmetto Regional Winner, Daimler Chrysler Team Spirit Award
2005 FL Regional Judges Award, FL Regional 3rd seeded and finalist, Palmetto Regional Xerox Creativity Award, Palmetto Regional 1st seeded and finalist
2004 UCF Regional Rookie All-star Award
Last edited by David Guzman : 31-01-2008 at 15:37.
|