Thread: project box
View Single Post
  #2   Spotlight this post!  
Unread 23-06-2002, 23:01
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: project box
Posted by Thomas Grupp.

Engineer on team #378, Circuit Stompers, from Newfane High School and Delphi Automotive Systems.

Posted on 2/5/2000 12:08 PM MST


In Reply to: project box posted by Justin Stiltner on 2/5/2000 12:20 AM MST:



: In the rules it says 'The black project box is intended to serv as a mounting point for the rocker switches, pushbutton switches, and potentiometers used by the robot operators, and to enclose the associated wiring. You may modify the project box in any manner to acomodate your needs.'

: does this mean that we MUST use the box only for that or is this just a suggestion? Can we use it on the the actual robot to enclose switches and associated wiring??

: Justin Stiltner
: Team 388


Justin

In my opinion, as long as it was in the kit the box can be used in any way you see fit. That means if you
want to use it on the robot, so be it.

As long as a part comes from either the kit, Small parts or the additional hardware list you can use it ON THE ROBOT!!

Have Fun

Tom Grupp
Team #378

__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.