Thread: NASA Sprockets
View Single Post
  #12   Spotlight this post!  
Unread 23-06-2002, 23:02
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
It's here
Posted by Samuel Lindhorst.

Engineer on team #240, Mach Vee, from Jefferson High School and Visteon.

Posted on 2/6/2000 6:27 PM MST


In Reply to: Can't find 'the NEW K1' posted by Joe Johnson on 2/6/2000 5:34 PM MST:



: Eric,

: I can't find the new K1 rule you mentioned.

: At least not in update #1.

: Anybody with some help out there?

: Joe J.

Update #3:

Q68. On page 33 of the Additional Hardware List (Appendix C), it says 'sprockets, gears and pulleys - any size, any amount.' Are we allowed to manufacture these sprockets, gears and pulleys to our specific requirements, or do we have to purchase them from stock items?
A68. Per the updated Rule K3 (see Team Update #1 on he FIRST web site), you may now fabricate your own gears, pulleys, and sprockets.

Sam


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.