|
Re: Compresser Wiring Help
You have to hook the pressure switch back to the Robot Controller. DO NOT HOOK IT IN SERIES WITH THE COMPRESSOR
Use a PWM Cable cut off the male end and wire the Ground and Signal Wires to the pressure switch (doesn't matter which terminal on the pressure switch). Then you can plug the female end into a digital input on the controller
For the Compressor hook it up to a Spike Relay
__________________
2010 to Present, Scorekeeper/Field Power Volunteer for FRC/FTC/FLL
2005 - 2010, Team 171 College Mentor
2002 - 2005, Team 930 Student
|