Thread: Lock it in and go!!!
View Single Post
  #1   Spotlight this post!  
Unread 23-06-2002, 23:04
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Lock it in and go!!!
Posted by nuts4first.

Engineer on team #340, GRR - Greater Rochester Robotics, from Churchville-Chili and Nortel Networks.

Posted on 2/7/2000 8:38 PM MST



We just finished testing our drive system and this works....

If you are looking for a quick and easy way to lock your drill gearbox in low or high gear try some O-rings. You'll need 2 per motor to get the correct width. They go in between the gears in the back half of the motor assembly case. I think we used 1-1/2 OD 1/8' wall.

Good luck. If you try it, let me know how you do with it.

-Team 340


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.