Thread: Course tolerances
View Single Post
  #1   Spotlight this post!  
Unread 23-06-2002, 23:04
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Course tolerances
Posted by Erik Justen.

Engineer on team #128, Cold Fusion, from Grandview Heights and The Ohio State University/American Electric Power.

Posted on 2/7/2000 10:23 PM MST



Someone posted this a while ago, but I couldn't seem to find it.

Does anyone know where I can find tolerances for the course dimensions? Someone specified +/- 1
inch, but I can't seem to find that number anywhere in the documentation. Can anyone point me in the right direction?

Thanks,
Erik


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.