Thread: # of limbo machines?
View Single Post
  #10   Spotlight this post!  
Unread 23-06-2002, 23:05
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: # of limbo machines?
Posted by Frank Saladino.

Coach on team #353, POBOTS, from Plainview CSD and Computer Associates.

Posted on 2/10/2000 9:37 PM MST


In Reply to: Re: # of limbo machines? posted by Donn Griffith on 2/9/2000 4:32 PM MST:



I like the idea of not being blocked at the ramp.

Our design is 13 inches high by 36 X 27 so far we have it all inside the envelope. I wish the light was a bit smaller.

Anyone else have the top of the light melt a hole in itself? Seems like a lesser wattage bulb would be in order.

BTW, we tried out the boom and claw on the bench today. It grabbed a roof girder and stuck to the ceiling. We bribed it with some Mobil 1 to get it down. . .

Good luck all.





__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.