[DarKCroNo]

Okay so as we turn the pot and if i connect the multimeter to the 2 outside pins, I see that 10 ohm's is continually shown. Our teacher had said thats where the black and red wires, + and -, cuz the pwm cable the red wire is in the middle so for this argument we'll say that black and red means - and +. so we connect the 2 outer pins and 10 ohms is continually shown no matter the position of the taper. But thats how we originally wired it.

Edit: I'm sorry I made a huge mistake, I had thought the PWM wires were the 2 outer wires were positive and negative but I looked again on the RC and its red and black are positive and negative. Sorry to bother you and thanks alot you gave me the idea to check!!