Thread: Wiring the VAN Door Motors
View Single Post
  #2   Spotlight this post!  
Unread 23-06-2002, 23:09
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: Wiring the VAN Door Motors
Posted by Nate Smith.

Other on team #66, GM Powertrain/Willow Run HS, from Eastern Michigan University and GM Powertrain.

Posted on 2/13/2000 10:24 PM MST


In Reply to: Wiring the VAN Door Motors posted by Amol Mittal on 2/13/2000 8:30 PM MST:



I don't know for sure on this...you will probably want to e-mail FIRST on this one, something that I think I will do myself, since I know that we're using those motors on our machine, and it is very soon to be handed over to the electrical team to get all the wiring done...

But anyway, I know that in one of the updates, they said it was allowed to use the wire pre-attached to the FP motors, which was a smaller gauge than the wire specified for those. I'm not sure if they will handle this one the same way or not, considering that the wires are not soldered to the motors...

I'm going to e-mail Eric on this one, and let everybody know what I find out...

Nate
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.