Thread: Wiring the VAN Door Motors
View Single Post
  #3   Spotlight this post!  
Unread 23-06-2002, 23:09
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: Wiring the VAN Door Motors
Posted by Thomas A. Frank.

Engineer on team #121, The Islanders/Rhode Warrior, from Middletown (RI) High School and Naval Undersea Warfare Center.

Posted on 2/14/2000 10:03 AM MST


In Reply to: Wiring the VAN Door Motors posted by Amol Mittal on 2/13/2000 8:30 PM MST:



Use 10 gauge wire from the speed controllers up to the short wires the manufacturer provides; you can leave the manufacturers wires alone.

Same with the Fisher Price motors (although I've got to tell you, it's worth the effort to run 10 gauge all the way to the F-P motors...we use just a very short stub of the manufacturers wire on the F-P motors to preserve the lugs)

Tom Frank


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.