Quote:
Originally Posted by Alan Anderson
Forgive the nagging, but are you absolutely certain the cables are inserted properly? There's a little nub of plastic in a new Victor's connector slot which often makes it difficult to plug the cables in fully unless you know exactly how to do it. Look carefully at how much of the connector is sticking out of the slot, and compare it to one that is working. You might find that it can go in another couple of millimeters.
|
Yeah, the PWM connector on the Victors are difficult to use. You should feel it "slide" into the connector is its lined up properly. Sometimes gently rocking, shaking, twist or jiggling the cable connector inside the victor connector can make it line up, and you will feel it slide down. Also, make sure your pins are straight on the end of the cable.
It is possible that the victors are bad, or that at one point were hooked up backwards like Ed suggested (
in which case, they are most certainly broken.) Contact IFI, and see what they say. They might have you send them back, and they'll charge a repair fee (they did that for us with the OI a few years back, after I boxed it by reversing the competition port pins
... They charged about half retail price for repair of the unit.)
Jacob