Thread: Drill Motor Anti-reverse Pins...
View Single Post
  #5   Spotlight this post!  
Unread 23-06-2002, 23:10
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
warning!!
Posted by Daniel.

Coach on team #483, BORG, from Berkeley High School and NASA Ames & UC Berkeley.

Posted on 2/18/2000 3:35 AM MST


In Reply to: Re: ditch 'em posted by Daniel on 2/18/2000 2:49 AM MST:



Don't follow my advice without using the right precautions!!

If you don't have a ramped deceleration programmed in for the drill motors....you're gonna go straight to break after you stop powering the drill motor. That would be BAD. I know you guys so I know you'll have it but I just wanted to make sure you don't try it witout a programmed decelearation.

-DL


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.