Thread: Using the IR
View Single Post
  #1   Spotlight this post!  
Unread 07-02-2008, 01:46
eugenebrooks eugenebrooks is offline
Team Role: Engineer
AKA: Dr. Brooks
no team (WRRF)
  
Join Date: Jan 2004
Rookie Year: 2001
Location: Livermore, CA
Posts: 601
eugenebrooks has a reputation beyond reputeeugenebrooks has a reputation beyond reputeeugenebrooks has a reputation beyond reputeeugenebrooks has a reputation beyond reputeeugenebrooks has a reputation beyond reputeeugenebrooks has a reputation beyond reputeeugenebrooks has a reputation beyond reputeeugenebrooks has a reputation beyond reputeeugenebrooks has a reputation beyond reputeeugenebrooks has a reputation beyond reputeeugenebrooks has a reputation beyond repute
Re: Using the IR
Your best bet would to be referencing the ground of the IR board directly to the ground of the digital inputs by connecting it there at the ports that you connect the signal pins to. One wire then runs to a 12 volt supply panel.
Reply With Quote