Thread: Blowing Relay Fuses
View Single Post
  #2   Spotlight this post!  
Unread 23-06-2002, 21:57
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: Blowing Relay Fuses
Posted by Tony K.

Student on team #292, PantherTech, from Western High School and DaimlerChrysler.

Posted on 2/22/2000 10:31 AM MST


In Reply to: Blowing Relay Fuses posted by Nate Smith on 2/22/2000 8:56 AM MST:



Open up the light housing and see if the positive terminal is shorting to the housing. Also, make sure it's mounted on Lexan or something else to insulate it from the robot body (ground fault, maybe?). Have you tried another spike?


Tony
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.