Thread: Blowing Relay Fuses
View Single Post
  #3   Spotlight this post!  
Unread 23-06-2002, 21:57
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: Blowing Relay Fuses
Posted by Nate Smith.

Other on team #66, GM Powertrain/Willow Run HS, from Eastern Michigan University and GM Powertrain.

Posted on 2/22/2000 11:40 AM MST


In Reply to: Re: Blowing Relay Fuses posted by Tony K on 2/22/2000 10:31 AM MST:



We've tried a few different spikes, and about 10 fuses so far...I actually called Eric earlier today, and he mentioned making sure we didn't have a ground fault, but didn't say anything about checking inside the housing...I'll pass this along to our pit crew, still hard at work tweaking the machine...luckily(?) the drayage site for our first event(Great Lakes) is just on the other side of town, so we can just drive it over there.

Nate
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.