Thread: Blowing drill motors
View Single Post
  #3   Spotlight this post!  
Unread 23-06-2002, 21:58
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: Blowing drill motors
Posted by S. Krussell.

Coach on team #349, Robahamas, from International Academy and Ford Motor Co..

Posted on 2/22/2000 5:44 PM MST


In Reply to: Re: Blowing drill motors posted by Nate Smith on 2/22/2000 11:44 AM MST:



We did not blow a drill motor, but they have become warm a few times. We did, however, blow the speed controller on one of the drill motors, plus the spike relay. We are a little concerned about the drill motors. I hope we can trust them to endure.


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.