Thread: BACKDRIVE PLEASE HELP!!!!!
View Single Post
  #13   Spotlight this post!  
Unread 23-06-2002, 21:58
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: One man's experience
Posted by Nate Smith.

Other on team #66, GM Powertrain/Willow Run HS, from Eastern Michigan University and GM Powertrain.

Posted on 2/23/2000 5:03 PM MST


In Reply to: One man's experience posted by Joe Johnson on 2/23/2000 3:30 PM MST:




: If you UNPLUG the robot from power, then there is no dynamic breaking, but if the Victor looses signal and it has the jumper in the dynamic braking mode (pins C & B shorted), then the internal CPU on the Victor continues to short the motor leads to each other (a.k.a. dynamically brake the motor).

I don't have a Victor right here to look at, but I believe it's the left two pins that turn breaking on, pins A and B.
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.