Thread: Help! I think we fried our OI!
View Single Post
  #2   Spotlight this post!  
Unread 09-02-2008, 18:53
Jim E Jim E is offline
Registered User
FRC #1523 (M.A.R.S.)
Team Role: Mentor
  
Join Date: Jun 2006
Rookie Year: 2005
Location: Lantana, FL
Posts: 188
Jim E has a reputation beyond reputeJim E has a reputation beyond reputeJim E has a reputation beyond reputeJim E has a reputation beyond reputeJim E has a reputation beyond reputeJim E has a reputation beyond reputeJim E has a reputation beyond reputeJim E has a reputation beyond reputeJim E has a reputation beyond reputeJim E has a reputation beyond reputeJim E has a reputation beyond repute
Re: Help! I think we fried our OI!
The 2005 pinout is correct. You should only have 4 wires connected to the 15 pin connector. This is the same for 2006-2008.

The diagram shows the pinout from the Solder cup side. Make sure you double check the pins.

Have you set your team number yet?. Does it work when tethered to the robot controller?

If you cannot troubleshoot the error, call IFI. Perhaps an internal protection fuse was blown due to improper wiring.
__________________
Team MARS = 1.523 AU from the SUN!

Jim E.