[vhcook]

I didn't think to take pictures when I was doing it this afternoon, and I can't get back into the shop until after work Monday, but here's a description of how I did it...

Required equipment:

- terminals for Keyang motor (see KOP checklist page 12 for photo)
- terminal housing (also on KOP checklist page 12)
- Wire (#12 AWG)
- Soldering Iron
- solder
- Needle nose pliers

The terminals break off the connecting strip (wiggle it back and forth a couple of times). Take one of the terminals and a piece of wire stripped to an appropriate length. Using pliers, bend the little metal tabs around the wire to hold it in position. Next, solder it in place. Once it cools off, perform the customary jiggle test to ensure the wire is solidly in place. Repeat with a second terminal.

On the back of the terminal is a little hook that will latch into the housing if inserted correctly. Before inserting it into the housing, you may want to test-fit the bare connector onto the motor's electrical connection to make sure it's ok. Once you're sure they're in good condition, insert the terminals into the plastic housing.

The housing will only fit onto electrical connector on the motor one way. The little tab on the side of the housing will lock into the motor's connector to keep things from working loose.

I hope this helps.