Thread: #25 sprockets with 1/4" bore and a keyway
View Single Post
  #1   Spotlight this post!  
Unread 10-02-2008, 14:01
Richard McClellan's Avatar
Richard McClellan Richard McClellan is offline
Engineering Mentor
FRC #0254 (Cheesy Poofs)
Team Role: Mentor
  
Join Date: May 2004
Rookie Year: 2004
Location: Palo Alto, CA
Posts: 322
Richard McClellan has much to be proud ofRichard McClellan has much to be proud ofRichard McClellan has much to be proud ofRichard McClellan has much to be proud ofRichard McClellan has much to be proud ofRichard McClellan has much to be proud ofRichard McClellan has much to be proud ofRichard McClellan has much to be proud ofRichard McClellan has much to be proud ofRichard McClellan has much to be proud of
Send a message via AIM to Richard McClellan
#25 sprockets with 1/4" bore and a keyway
Does anyone know where we could find some #25 sprockets with a 1/4" bore and a 3/32" keyway? I would really like to stick with the 1/4" bore for another reason specific to our design, but even though keyed parts are harder to find in that size. \

We're planning on getting 1/4" shaft with a 3/32" key slot from mcmaster, but they don't have keyed sprockets in that size. We have a 1/8" key broach, but would prefer not to have to buy a 3/32" broach.

Any suggestions?
__________________
~ Richard McClellan ~
Former Student on 1477 | Northside Roboteers | 2004-2005
Former Lead Mentor for 2158 | ausTIN CANs | 2007-2010
Current Mentor for 254 | Cheesy Poofs | 2013