Thread: How do you control the length a piston will extention/retraction?
View Single Post
  #4   Spotlight this post!  
Unread 11-02-2008, 04:31
Kirk Kirk is offline
Registered User
FRC #0254
Team Role: Engineer
  
Join Date: Jan 2002
Rookie Year: 1997
Location: Woodside, CA
Posts: 97
Kirk has much to be proud ofKirk has much to be proud ofKirk has much to be proud ofKirk has much to be proud ofKirk has much to be proud ofKirk has much to be proud ofKirk has much to be proud ofKirk has much to be proud ofKirk has much to be proud of
Send a message via AIM to Kirk
Re: How do you control the length a piston will extention/retraction?
If you are trying to control the length of a cylinder you want a "center off or center closed" solenoid. Instead of the spool inside moving and staying in position to supply air to port A or port B, when it gets power only momentary to allow air into port A or B allowing for small adjustments of a cylinder. As stated above this can be tricky since the air in the cylinder isn't the full regulated pressure but an average and can act like a spring. If you are interested in these contact SMC and they can help you select the proper one for your situation.