Thread: control devices
View Single Post
  #5   Spotlight this post!  
Unread 23-06-2002, 22:06
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Not as wide open as I would like (was Re: Door is wide open)
Posted by Thomas A. Frank.

Engineer on team #121, The Islanders/Rhode Warrior, from Middletown (RI) High School and Naval Undersea Warfare Center.

Posted on 2/28/2000 3:07 PM MST


In Reply to: Re: Door is wide open posted by Raul on 2/27/2000 7:06 PM MST:



: I though Eric said 'anything goes - just don't create a control room on wheels.'


Not quite...yes, all the 100K pots and switches non-lighted (but you CAN drill a whole and put in one of the kit LED's if you want) switches you would like. However, you cannot use, say, RJ-45 jacks/cables to assemble the harness (which is what I wanted to do to simplify attachment and disassembly).

We ended up with a simple layout, as our machine just isn't that complex from the operators perspective.

Tom Frank


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.