Thread: pneumatics with easyC
View Single Post
  #2   Spotlight this post!  
Unread 13-02-2008, 10:03
klondike klondike is offline
Registered User
FRC #1023
  
Join Date: Mar 2007
Location: Temperance, MI
Posts: 1
klondike is an unknown quantity at this point
Re: pneumatics with easyC
The pistons are controlled with a spike, so you just have to use a relay on the RC to control them and map that to the buttons. The air compressor needs the pressure switch and doesn't need a button, it will turn off if there is pressure and on if it needs to build some up. If you still want to have the button control the compressor you can put the pressure switch block in easyC inside of an if statement for the button, but I think just letting it do its thing would be fine, unless your concerned with battery life or something...