View Single Post
  #3   Spotlight this post!  
Unread 23-06-2002, 22:11
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
 
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
my interpretation

Posted by Nate Smith.

Other on team #66, GM Powertrain/Willow Run HS, from Eastern Michigan University and GM Powertrain.

Posted on 2/29/2000 7:01 PM MST


In Reply to: Interesting response... posted by Joe Johnson on 2/29/2000 6:04 PM MST:



: This is a very interesting response from FIRST.

: How then are we to determine what is an unlimited 'material' and what is forbidden?

: 100Kohm pots are allowed as long as they are linear taper and wired as indicated.

: Switches of any kind are allowed as long as they are wired as indicated.

: Wire: it too is allowed.

: Plastic: Allowed

: Put them all together: Not allowed

: What if a team used a joystick only for its switches?

: Let's say that FIRST says, No, this is not allowed. Then what about a larger industrial palm switch from McMaster say? Is this allowed as a switch or disallowed as a joystick?

: How are we to decide where a legal linear tape pot or a standard switch in an unlimited material ends and an illegal component begins?

: How is this going to be determined?

: Joe J.


Here's how i'd interpret this...
homemade = ok
off-the-shelf(due to possible incompatibilites) = not ok

Nate
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.