Thread: all the great help!!!
View Single Post
  #1   Spotlight this post!  
Unread 23-06-2002, 22:15
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
all the great help!!!
Posted by Jimmy Holmes.

Coach on team #27, Team RUSH, from Osmtech Academy and DaimlerChrysler.

Posted on 3/3/2000 6:09 AM MST



Thank you all for the great input!! I believe the first thing we will at great lakes
is tie the two arms together better. Plus redo the cal on the speed controllers and check the tension
screw on the van door motors.Things we should have done to start off with I think... late nights
cause rash thinking. Someone asked how the motors were facing..they are facing with the shafts forward
and horizontal and they are attached to a worm gear, one on each side of the robot. Which move two short arms
arms up and down at the same time (in theory) I agree if we do the simple things first we will not need
the clever program.. I think I just needed to hear it from others... again thank you for your help.
Team 27's Jack of all trades Jimmy Holmes


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.