Thread: RAGE Pics
View Single Post
  #4   Spotlight this post!  
Unread 23-06-2002, 22:16
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: You're underestemating us...
Posted by Steve Prairie.

Student on team #173, RAGE, from Rockville High School /East Hartford High School and UTRC.

Posted on 3/6/2000 3:59 PM MST


In Reply to: Don't Lose That Much Sleep! posted by Eric Fleming on 3/5/2000 5:00 PM MST:



If you think that RAGE came into that scrimmage with weeks of practice, a fully operational robot, and a strategy, you should wake up. We used this opertunity as a practice. None of the drivers had touched the controlls until that night. Instead of having only two drivers, we used the time as a tryout. We let everybody that wanted to, drive, no matter what their skill level was. Also, the first three matches we played in, we had a communication problem with the competition ports, if we had been up and running then, we would have probably won and added another 20+ points to our score. We 2 wern't finished with our robot, we hadn't had the limit switches on, nor did we run in high gear.

So if you take that scrimmage as a scouting report of RAGE, you'll be very suprised to see us when we are all set.

Steve Prairie
RAGE Team #173

P.S. Almost every match we were in, we competed 1 aginst 2.

And we did push OTIS off the ramp, so it didn't matter if they could hang or not then.

So we'll just hafta wait untill the regionals...



__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.