View Single Post
  #4   Spotlight this post!  
Unread 17-02-2008, 01:32
dtengineering's Avatar
dtengineering dtengineering is offline
Teaching Teachers to Teach Tech
AKA: Jason Brett
no team (British Columbia FRC teams)
Team Role: Mentor
 
Join Date: Jan 2005
Rookie Year: 2004
Location: Vancouver, BC
Posts: 1,829
dtengineering has a reputation beyond reputedtengineering has a reputation beyond reputedtengineering has a reputation beyond reputedtengineering has a reputation beyond reputedtengineering has a reputation beyond reputedtengineering has a reputation beyond reputedtengineering has a reputation beyond reputedtengineering has a reputation beyond reputedtengineering has a reputation beyond reputedtengineering has a reputation beyond reputedtengineering has a reputation beyond repute
Re: CIM Pinion issues in Toughbox

That makes sense... if the key was longer then the clip could have been pushed down over it, thus allowing it to sneak out as you drove.

The fix you have posted sounds pretty much foolproof, though, and fortunately it happened at a time when you had time to investigate and repair.

About our only "discovery" so far has been that unless the compressor is very well supported and restrained, that those little rubber vibration dampers shear off quite easily in a high-speed impact with a cement wall.... even with bumpers on.

Okay... after SEVERAL high-speed impacts with a cement wall.

Jason