|
Re: digital inputs: some bad?
I haven't looked into this all that much, but we plugged the IR board into 15-18, and could not seem to get the buttons associated with 17 or 18 to register in code. We moved the signal connector to 13-16, and it worked just fine. I was busy with a lot of other things, so I chalked it up to either subtle user error or gremlins in the system, but I'm a little surprised to hear that this may be a common occurrence.
EDIT: We definitely set the pins to be inputs. Also, if I remember correctly, the RobotC debugger window wouldn't even display a value for those pins. Bizarre.
__________________
Team 1743 - The Short Circuits
2010 Pittsburgh Excellence in Design & Team Spirit Awards
2009 Pittsburgh Regional Champions (thanks to 222 and 1218)
2007 Pittsburgh Website Award
2006 Pittsburgh Regional Champions (thanks to 395 and 1038)
2006 Pittsburgh Rookie Inspiration & Highest Rookie Seed
Team 1388 - Eagle Robotics
2005 Sacramento Engineering Inspiration
2004 Curie Division Champions (thanks to 1038 and 175)
2004 Sacramento Rookie All-Star
_
Last edited by jgannon : 18-02-2008 at 23:32.
|