Quote:
Originally Posted by 3dude_2231
what programmer are you using? (ICD2?)
what software do you use with it?
|
I'm using iambujo's method of a serial dongle connected to the board.
Quote:
Originally Posted by iambujo
Check out the screen shot in my powerpoint slides. Under the interface tab I selected "JDM (2) for serial port" under Interface Type, and then I loaded the ElCheapo_PCB.ini for the definition file. This was via trial and error before I got "success". Maybe that will help if you didn't do that.
|
Yes, I saw that and set both of them. Maybe I'll try again on a different computer. Thanks for your help. Its strange because I can connect, erase, read, verify, etc. I just cannot write the hex file. Perhaps it is the voltage levels.