Thread: WARNING...Dr. Joe's advice on the drill shaft is incomplete!
View Single Post
  #1   Spotlight this post!  
Unread 23-06-2002, 22:31
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
WARNING...Dr. Joe's advice on the drill shaft is incomplete!
Posted by nuts4first.

Engineer on team #340, GRR - Greater Rochester Robotics, from Churchville-Chili and Nortel Networks.

Posted on 3/22/2000 10:13 PM MST



++++++++++++++++++++++++
F L A S H B U L L E T I N
++++++++++++++++++++++++

If you have taken Dr. Joe's advice by producting a replacement drill gearbox output shaft as described in 'Dr. Joes Drill Advice' step # 5 and as seen in the drawing 'Dr. Joes Drill Shaft' (in the lower right hand corner) be warned!

The drawing is missing a critical cut at the aft end of the shaft, in the middle of the 4 pins. If you are using this technique in your robot's drive system be cautious. A ~




__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.