Thread: Drill motor mod.
View Single Post
  #1   Spotlight this post!  
Unread 23-06-2002, 22:34
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Drill motor mod.
Posted by Justin Stiltner.

Student on team #388, Epsilon, from Grundy High School and NASA, American Electric Power, Town of Grundy.

Posted on 3/27/2000 8:56 PM MST



Dear everybody,
Has anyone managed to remove the pinion from the shaft of the drill motor or the fisher price motor? if so I would be very thankfull if you were to post just how you did this. Does anybody evean know how they are attached? it looks like they are pressed on but that doesent seem correct.
Thanks for the help and see you at nationals.

Justin Stiltner
Team 388
Grundy High School





__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.