Thread: We Need Help!!!!!!!
View Single Post
  #6   Spotlight this post!  
Unread 23-06-2002, 22:39
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: Eliminating a few other things...
Posted by Travis Covington.

Student on team #115, MV ROBOTICS, from Monta Vista High School and Hitachi Data Systems - 3com - NASA Ames.

Posted on 4/2/2000 3:59 PM MST


In Reply to: Re: Eliminating a few other things... posted by Jerry Eckert on 4/2/2000 3:32 PM MST:



: Is the motor on the bad side running significantly
hotter than the opposite side?


Not really. As soon as we install a new one it seems
to be fine. The are equally warm (not hot). But after
we have it out on the floor under some load the current
draw just sky rockets, and the motor is shot. We are
pretty sure that it is not a problem w/ side loads or
too much friction.


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.