Thread: Info on gear on drill motor
View Single Post
  #1   Spotlight this post!  
Unread 23-06-2002, 22:58
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Info on gear on drill motor
Posted by Jason Iannuzzi.

Engineer on team #11, Marauders, from Mt. Olive HS. and BASF, Rame Hart, CCM.

Posted on 5/4/2000 7:24 AM MST



Anyone happen to know the pitch/pressure angle on the gear on the drill motors?

We don't have a gear gauge (or at least can't find the one we had) but we need the info.

We're hoping to make our own gearboxes and avoid all the hassle associated with the out-of-the-box ones.

Hey, we gotta keep ourselves occupied somehow right?


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.