Thread: Pit Size
View Single Post
  #18   Spotlight this post!  
Unread 06-03-2008, 12:13
Syncopation's Avatar
Syncopation Syncopation is offline
I can't make a dongle outta 25-pin!
FRC #0932 (Memorial Circuit Chargers)
Team Role: Programmer
 
Join Date: Jan 2007
Rookie Year: 2006
Location: Tulsa, OK
Posts: 34
Syncopation has a spectacular aura aboutSyncopation has a spectacular aura aboutSyncopation has a spectacular aura about
Send a message via ICQ to Syncopation Send a message via AIM to Syncopation Send a message via MSN to Syncopation Send a message via Yahoo to Syncopation
Re: Pit Size

Quote:
Originally Posted by Richard View Post
And your team had a truly great pit. The best example of 5S that I have seen at a FIRST event.

This year we reduced pit width (side-to-side) from 10ft. to 9ft. We did it so we could reduce the number of aisles four to three and increase aisle width from 10ft. to 13ft. The goal was to keep traffic congestion to a minimum, and still have space for a practice carpet. A few teams with pre-built 10ft. wide pit structures had to adjust, or borrow space from neighbors.
While a pit smaller than the 10x10x10 can be a little cramped sometimes, St. Louis has had a few issues with pit traffic in the past... well, maybe more than a few. So opening up those aisles was definitely a great improvement over past years.

We had a pre-built pit entrance that was 10' wide, but luckily, we had an end pit. Turning our entrance towards the pit admin table solved some problems, and created new ones... I don't think the judges were too happy with our over-zealous team members crowding around and spilling into the aisle a bit too often. :3

Going to the OKC regional will be a big change - I hear they have enough room in the Ford Arena for 10x15x10 pits...
__________________
Team 932:
2008 Oklahoma City Xerox Creativity Award
2008 Oklahoma City Autodesk Visualization Award
2008 St. Louis Chairman's Award winner
Home of the 2008 St. Louis Woodie Flowers mentor
2007 Kansas City Engineering Inspiration winner
2006 Lone Star Regional Finalist alliance member

---
A mathmatician, a physicist, and an engineer were all given a red rubber ball and told to find the volume.
The mathmatician carefully measured the diameter and evaluated a triple integral.
The physicist filled a beaker with water, put the ball in the water, and measured the total displacement.
The engineer looked up the model and serial numbers in his red-rubber-ball table.