Thread: Command to enter program mode?
View Single Post
  #6   Spotlight this post!  
Unread 11-03-2008, 22:21
whitetiger0990's Avatar
whitetiger0990 whitetiger0990 is offline
Registered User
no team
Team Role: Programmer
  
Join Date: Mar 2006
Rookie Year: 2006
Location: Earth
Posts: 157
whitetiger0990 is a glorious beacon of lightwhitetiger0990 is a glorious beacon of lightwhitetiger0990 is a glorious beacon of lightwhitetiger0990 is a glorious beacon of lightwhitetiger0990 is a glorious beacon of light
Re: Command to enter program mode?
We also use a cable from a digital port to the programming pin. I'm not sure if what tdlrali said is correct. At least connecting the grounds together is unneeded, and won't do anything. I'm pretty sure I remember taking the white signal pin from the digital port to the middle pin of the Reset/Prog pins. I think the left most one is Reset, the middle on is Program, and the far right is ground. You just need the signal to connect to the the middle pin of those three to the signal of the digital port.
__________________
print$q=chr(ord($q)+$1)while("7443-0201-8465130105-12-03135-82482113-06-7672-070208-0613-70"=~/(-?\d\d)/g);