Thread: RC Analog Pins not working
View Single Post
  #2   Spotlight this post!  
Unread 11-03-2008, 23:38
whytheheckme's Avatar
whytheheckme whytheheckme is offline
Registered User
AKA: Jacob Komar
no team
  
Join Date: Feb 2006
Rookie Year: 2005
Location: Providence, RI
Posts: 1,320
whytheheckme has a reputation beyond reputewhytheheckme has a reputation beyond reputewhytheheckme has a reputation beyond reputewhytheheckme has a reputation beyond reputewhytheheckme has a reputation beyond reputewhytheheckme has a reputation beyond reputewhytheheckme has a reputation beyond reputewhytheheckme has a reputation beyond reputewhytheheckme has a reputation beyond reputewhytheheckme has a reputation beyond reputewhytheheckme has a reputation beyond repute
Send a message via ICQ to whytheheckme Send a message via AIM to whytheheckme Send a message via MSN to whytheheckme Send a message via Yahoo to whytheheckme
Re: RC Analog Pins not working
Quote:
Originally Posted by Al Skierkiewicz View Post
We found a few 2008 RC loaded with Version 13 code in Chicago. If your code cannot run on V13 then that might be the problem. To check, tether up and power the robot. Press the button underneath the team numbers on your OI to cycle through the readout and you will get to a display that starts with a v followed by two numbers. It should be v15 but if it is v13 you will have to reload the firmware and then your software. Just a possible solution...
I believe the rules say that if you are to use an '07 RC, it needs to be brought up to v15.

Can't find the quote though, so I could be wrong. I just seem to remember pulling out my '07 RC after reading that somewhere to upgrade it, just incase we ever needed to do a swap.

Jacob