[RyanN]

Originally Posted by billbo911

OK, that's the same sensor we used this year.
May I suggest you re-position your sensor closer to the teeth. Ours id currently approximately .5 to 1mm from the teeth and works perfectly.
Here is a picture. In fact, it is too far out in this picture. We ended up moving it in even closer.


If you look closely, you can see two washers used as spacers. We removed the thicker one and our intermittents went away.

We will try it when we get to the Bayou Regional, but 2 days before shipping, we measured it with a feeler, and it was pretty much right on what it called for, and one of our engineers doesn't want to get it "too close."