Thread: I need some bright ideas. What to do with a POWER DRILL....
View Single Post
  #5   Spotlight this post!  
Unread 23-06-2002, 23:14
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
hmm... plexiglass
Posted by Erin.   [PICTURE: SAME | NEW | HELP]


Student on team #1, The Juggernauts, from Oakland Technical Center-Northeast Campus and 3-Dimensional Services.

Posted on 6/15/2000 10:53 PM MST


In Reply to: I need some bright ideas. What to do with a POWER DRILL.... posted by Anton Abaya on 6/15/2000 12:29 AM MST:



go to your local ACE hrdware or whatever hardware stores you have out there on the east coast and buy some material (some plastics, plexiglass). Use vertical band saw to cut to lengths of 55mm x 80mm. drill holes in one of the corners and then make designs on them with cnc mill.
oh what, you don't have a band saw or a cnc mill? sorry, i don't think you can get those at hardware stores...
i'll think of something else...
you could make some dice with a band saw, some sandpaper and a drill press with a small bit... think about it.. im blabbering..
-Erin


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.