Thread: Looking for aluminum wire
View Single Post
  #5   Spotlight this post!  
Unread 23-06-2002, 23:48
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
clarification... :)
Posted by Janna.

Student on team #349, The RoBahamas, from International Academy and Ford Motor Company.

Posted on 9/14/2000 6:57 PM MST


In Reply to: McMaster to the Rescue... posted by Joe Johnson on 9/14/2000 10:35 AM MST:



Hey,

Just wanted to clarify to everyone...we aren't planning on rewiring the *insides* of the motors...I guess that was a little misleading. Just *replacing* the regular 10 gauge wire between the motors and speed controllers and other things... So yeah, we aren't planning on dissecting the motors and frying them...honestly, even if we wanted to we probably wouldn't know how. Thanks for all the warnings and the sources though!

Janna



__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.