Thread: Addition
View Single Post
  #4   Spotlight this post!  
Unread 24-06-2002, 00:06
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Square Ball Rack & Out of Bounds
Posted by Joe Johnson.   [PICTURE: SAME | NEW | HELP]


Engineer on team #47, Chief Delphi, from Pontiac Central High School and Delphi Automotive Systems.

Posted on 10/14/2000 3:11 PM MST


In Reply to: Re: Inside Dim of Square posted by Raul on 10/14/2000 12:23 PM MST:



How about this proposal?

1) If the rack is touching the ground out of bounds, it does not count as a doubler.

2) If the rack goes out of bounds, it will not be returned to the field by the officials.

3) A robot may attempt to bring the square rack back in bounds but if the robot touches the ground out of bounds while it is attempting to bring the rack back in bounds, it will be declared out of bounds itself -- very perilous work, reclaiming out of bounds square racks.

Official rulings will follow, but I would like comments on this proposal if any exists.

Joe J.



__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.