Thread: Notes on building the Square Rack
View Single Post
  #2   Spotlight this post!  
Unread 24-06-2002, 00:06
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: Notes on building the Square Rack
Posted by Michael Martus.   [PICTURE: SAME | NEW | HELP]


Coach on team #47, Chief Delphi, from Pontiac Central H.S. and Delphi Automotives Systems.

Posted on 10/14/2000 6:03 PM MST


In Reply to: Notes on building the Square Rack posted by Joe Johnson on 10/14/2000 3:24 PM MST:



All elbows are not created equal... I would have thought that there was an indusrty standard. But that was not true even at the same store, as I made two trips to get like items.

Maintain the inside distance between flats and you are all set.

My elbows used lengths that were 22.5 inches long.


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.