Thread: hieght of the scoring ramp
View Single Post
  #2   Spotlight this post!  
Unread 24-06-2002, 00:08
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: hieght of the scoring ramp
Posted by Nate Smith.

Other on team #66, GM Powertrain/Willow Run HS, from Eastern Michigan University and GM Powertrain.

Posted on 10/17/2000 12:47 PM MST


In Reply to: hieght of the scoring ramp posted by Pat on 10/17/2000 9:59 AM MST:



: In the diagram of the scoring ramp, they do not asign a measurement to the height of the back. Does anybody know the angle of the ramp. If so, please respond.

The height of the peak is approx. 6 inches, according to one of Joe's posts earlier today...linked to below. Also, the angled surface of the ramp is made of a 48x48 piece of plywood(again from Joe's post). This should give you the information you need to calculate the angle. Hope this helps...

Nate
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.