Thread: Material list suggestion
View Single Post
  #1   Spotlight this post!  
Unread 24-06-2002, 00:10
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Material list suggestion
Posted by Philip.

Student on team #45, TechnoKats, from Kokomo High School and Delphi .

Posted on 10/18/2000 11:21 AM MST



After doing some math when trying to figure up some gear ratios, I found that chain is of the essence when designing the robot this year. If four of the extra large sprockets were used, almost all of the chain would be used to just wrap around the sprockets. Leaving very little chain to use for gearing down or for other applications on the robot. Is it possible the amount of chain that can be used could be upgraded by a few feet? If not, does anyone know how to conserve enough chain to get the correct gear ratio?
Phil



__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.