Thread: Building material
View Single Post
  #2   Spotlight this post!  
Unread 24-06-2002, 00:10
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
No 80/20
Posted by Joe Johnson.   [PICTURE: SAME | NEW | HELP]


Engineer on team #47, Chief Delphi, from Pontiac Central High School and Delphi Automotive Systems.

Posted on 10/18/2000 7:33 PM MST


In Reply to: Building material posted by Jason Baker on 10/18/2000 7:25 PM MST:



Question:

Can we use 80/20 products, that we have laying around from the 2000 FIRST competition?

Answer:

The Additional Hardware List says: 'Aluminum Angle/Box/Tube' I don't think that the typical 80/20 extrusions meet my definition of an aluminum angle, box or tube. So the answer is no. Sorry.


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.