Thread: Wheel Attachment to sprocket/shaft?
View Single Post
  #1   Spotlight this post!  
Unread 24-06-2002, 00:15
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Wheel Attachment to sprocket/shaft?
Posted by Nate Smith.

Other on team #66, GM Powertrain/Willow Run HS, from Eastern Michigan University and GM Powertrain.

Posted on 10/26/2000 4:33 PM MST



In the pictures section, there is a set of pictures showing how to attach a sprocket and wheel to a shaft. However, it is somewhat unclear as to what is actually being done in some of the pictures. Is is possible to get a short written set of instructions, describing what is being done in the pictures? Thanks...

Nate
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.