Thread: Legal material?
View Single Post
  #2   Spotlight this post!  
Unread 24-06-2002, 00:16
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Q&A: U != L
Posted by Joe Johnson.   [PICTURE: SAME | NEW | HELP]


Engineer on team #47, Chief Delphi, from Pontiac Central High School and Delphi Automotive Systems.

Posted on 10/29/2000 7:06 AM MST


In Reply to: Legal material? posted by Dung Cao on 10/28/2000 9:19 AM MST:



Question:

Is the use of aluminum u-channel acceptable? Or do we have to cut an aluminum tube in half?

Answer:

I think perhaps we should have included U channel on the list, but we didn't. At this point, I think many teams have put in too much time building with the kit we have to add this now, especially when teams can cut a box section in half or bolt two angles together in order to achieve much the same effect.

So...

Bottom line, U channel does not qualify as Tube, Angle or Box.

Joe J.


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.