View Single Post
  #1   Spotlight this post!  
Unread 14-04-2008, 15:22
RoarRoar RoarRoar is offline
Registered User
no team
 
Join Date: Jan 2008
Location: Norway
Posts: 8
RoarRoar is an unknown quantity at this point
help with Operator Interface and FRC robot Controller

Hello

I have make a submarine and I will use Operator Interface and FRC robot Controller to control my 4 motors (thrusters) on submarine.

Sow I need some help with my Operator Interface and FRC robot Controller.
The Operator Interface and FRC robot Controller is new,sow i dont no what I shall do.however
I have connect all cables,2 Analog joystick and the 4 Motor Controls to FRC robot Controller and the Operator Interface,I use two RS232 converter to RS485 instead of Radio Modem, because the Radio Modem don`t work under the water, sow I have a long cabel.

When I power up Operator Interface and the FRC robot Controller with RS232 converter to RS485, the LEDs indicator on Operator Interface and FRC robot Controller indicate this:

FRC robot Controller

Battery Power : GREEN Blink
Program State : GREEN Blink
Radio Modem : RED Solid
RC Hardware : GREEN blink
RC Mode : OFF/ no LED


Operator Interface


Operator Interface

POWER ON : GREED Solid
DATA TX : GREED Solid
VALID RX : GREED Solid
NO DATA/Radio : NO LED
MAIN Fault : NO LED
AUX Fault : NO LED
RADIO Fault : NO LED
INTERNAL Fault : NO LED

Robot controller

VALID RX : GREEN Blink
NO MAIN BATT : RED Solid
LOW MAIN BATT : Orange Solid
CODE ERROR : RED Solid
BACKUP BATT : NO LED


I will take a photo off Operator Interface and the FRC robot Controller to morrow.

Last edited by RoarRoar : 14-04-2008 at 15:26.