Thread: Loc-Tite
View Single Post
  #2   Spotlight this post!  
Unread 24-06-2002, 00:23
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: Loc-Tite
Posted by Michael Martus.   [PICTURE: SAME | NEW | HELP]


Coach on team #47, Chief Delphi, from Pontiac Central H.S. and Delphi Automotives Systems.

Posted on 11/8/2000 7:18 PM MST


In Reply to: Loc-Tite posted by Jason Baker on 11/8/2000 5:31 PM MST:



The Lock - tight rule is there so we can re-use the parts next year. Also remember we (my class) will have to disassemble the robot if you do not.

I suggest the following:
1. Use 'Lock Washers', the sharp edge bites well into the alum.
2. Use nuts that have 'Nylock' inserts they work great. ( this is what we always use ) on assemblies.

Do not use Lock tight on our parts. Your bolts and nuts are ok, I would suggest however the answers I have suggested not the chemical answer.





__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.