Thread: Gas Strut Assembly End Fixtures
View Single Post
  #1   Spotlight this post!  
Unread 24-06-2002, 00:24
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Gas Strut Assembly End Fixtures
Posted by Janna.

Student on team #349, The RoBahamas, from International Academy and Ford Motor Company.

Posted on 11/9/2000 5:40 PM MST



In looking at the gas strut assemblies we received, we noticed that the two shorter ones had different endpieces. One has two triangular shaped ones, while the other has one triangular endpiece and one rectangular endpiece. Are these pieces supposed to be this way? If not, would you like us to bring it and exchange it? Thanks!

Janna
Team 349


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.